Do I need to consider the installation location when selecting and installing air valve fittings?

When selecting and installing air valve fittings, it is indeed necessary to fully consider the issue of installation location. This is because the installation position of the air valve has a crucial impact on its normal function and service life.
Firstly, when selecting the installation location, it is necessary to ensure that the air valve can smoothly perform its main functions, namely exhaust and intake. This usually means that the air valve should be installed at the high point or protruding part of the pipeline, such as the raised position of the pipeline (also known as the knee point or hump), the position where the hydraulic slope or pipeline slope changes, especially at the front and rear ends of the sudden slope change point.
Secondly, the safety of the installation location is also a factor that must be considered. The air valve should be installed in a safe and reliable place to avoid accidental impact or damage from external factors. At the same time, it is also necessary to pay attention to the temperature and humidity conditions of the installation environment, avoid installing in low-temperature areas to prevent gas freezing and blockage, and also avoid damaging the air valve due to moisture in humid environments.
In addition, the installation direction of the air valve is closely related to its function. Usually, the installation direction of the air valve should be perpendicular to the flow direction of the medium to avoid excessive medium flow, which may cause the air valve to close poorly or leak air. If the installation direction is parallel to the flow direction of the medium, the valve must be installed in the cross-section of the pipeline and ensure that its diameter matches the diameter of the pipeline to ensure unobstructed flow of the medium.
Finally, when installing the air valve, it is necessary to follow the specific product instructions and technical requirements, including removing debris from the main body, installing a gate valve in front of the exhaust valve for maintenance, and ensuring that the valve has sufficient space for adjustment and maintenance. These steps are important steps to ensure that the air valve can work properly and extend its service life.