简体中文
English
Copyright 2022 © Ningbo Xinmadi Automation Technology Co., Ltd. All Rights Reserved.
Wholesale Pneumatic Products Manufacturers
Cleaning the AW filter pressure reducing valve involves the following steps:
Shut off the water supply: Turn off the water supply to the valve to prevent any water from flowing while you are cleaning it.
Remove the valve from the system: Remove the valve from the plumbing system by unscrewing it from the pipes or connections. Make sure you have a bucket or container to catch any water that may leak out of the pipes.
Disassemble the valve: Carefully disassemble the valve by removing the bonnet, diaphragm, spring, and other components.
Clean the filter: The filter is usually located inside the valve body, and it can be removed by unscrewing it or pulling it out. Use a soft-bristled brush or a toothbrush to clean the filter thoroughly, removing any dirt or debris that may have accumulated.
Clean the other components: Use a damp cloth or sponge to clean the other components of the valve, such as the bonnet, diaphragm, and spring. Make sure you remove any dirt or debris that may have accumulated.
Reassemble the valve: Once all the components are clean and dry, reassemble the valve in the reverse order that you took it apart. Make sure all the components are properly aligned and tightened.
Reinstall the valve: Once the valve is reassembled, reinstall it in the plumbing system by screwing it back onto the pipes or connections.
Test the valve: Turn on the water supply and test the valve to make sure it is functioning properly. Check for any leaks or irregularities in the water pressure.
